LoongArch: Fix AP booting issue in VM mode

Native IPI is used for AP booting, because it is the booting interface
between OS and BIOS firmware. The paravirt IPI is only used inside OS,
and native IPI is necessary to boot AP.

When booting AP, we write the kernel entry address in the HW mailbox of
AP and send IPI interrupt to it. AP executes idle instruction and waits
for interrupts or SW events, then clears IPI interrupt and jumps to the
kernel entry from HW mailbox.

Between writing HW mailbox and sending IPI, AP can be woken up by SW
events and jumps to the kernel entry, so ACTION_BOOT_CPU IPI interrupt
will keep pending during AP booting. And native IPI interrupt handler
needs be registered so that it can clear pending native IPI, else there
will be endless interrupts during AP booting stage.

Here native IPI interrupt is initialized even if paravirt IPI is used.

Cc: stable@vger.kernel.org
Fixes: 74c16b2e2b0c ("LoongArch: KVM: Add PV IPI support on guest side")
Signed-off-by: Bibo Mao <maobibo@loongson.cn>
Signed-off-by: Huacai Chen <chenhuacai@loongson.cn>
This commit is contained in:
Bibo Mao 2024-11-12 16:35:39 +08:00 committed by Huacai Chen
parent 139d42ca51
commit 6ce031e5d6

View File

@ -51,11 +51,18 @@ static u64 paravt_steal_clock(int cpu)
}
#ifdef CONFIG_SMP
static struct smp_ops native_ops;
static void pv_send_ipi_single(int cpu, unsigned int action)
{
int min, old;
irq_cpustat_t *info = &per_cpu(irq_stat, cpu);
if (unlikely(action == ACTION_BOOT_CPU)) {
native_ops.send_ipi_single(cpu, action);
return;
}
old = atomic_fetch_or(BIT(action), &info->message);
if (old)
return;
@ -75,6 +82,11 @@ static void pv_send_ipi_mask(const struct cpumask *mask, unsigned int action)
if (cpumask_empty(mask))
return;
if (unlikely(action == ACTION_BOOT_CPU)) {
native_ops.send_ipi_mask(mask, action);
return;
}
action = BIT(action);
for_each_cpu(i, mask) {
info = &per_cpu(irq_stat, i);
@ -147,6 +159,8 @@ static void pv_init_ipi(void)
{
int r, swi;
/* Init native ipi irq for ACTION_BOOT_CPU */
native_ops.init_ipi();
swi = get_percpu_irq(INT_SWI0);
if (swi < 0)
panic("SWI0 IRQ mapping failed\n");
@ -193,6 +207,7 @@ int __init pv_ipi_init(void)
return 0;
#ifdef CONFIG_SMP
native_ops = mp_ops;
mp_ops.init_ipi = pv_init_ipi;
mp_ops.send_ipi_single = pv_send_ipi_single;
mp_ops.send_ipi_mask = pv_send_ipi_mask;